Wszystkie modele

Sortowanie

Liczymy pasujące modele…

3.5"/2.5" Storage Drive Stacking Mount

Compatible with both 2.5" and 3.5" hard drives and SATA SSDs. Print settings don't really matter, just make sure to use enough top/bottom layers. You can print two mirror racks like in the third picture by mirroring the rack in the…

Pobrania
58
Polubienia
29
Ocena
5

DIY Phone Tripod

To build this model, you will need the following: HARDWARE Seven: M4x25mm screws Seven: M4 nuts Three: 24" (610mm) lengths of half-inch PVC pipe One: 13" (330mm) length of half-inch PVC pipe Three: 36" (915) lengths of half-inch wooden…

Pobrania
15
Polubienia
11
Ocena
0

Modern Minimalist Desk Clock - Compatible with Bambu Labs Clock Components Kit 011

To build this project with, you will need One: HR-1688 quartz wall clock replacement mechanism (This model is compatible with the Bambu Labs Clock Components Kit 011 Glue of your choice (I highly recommend CA/super glue) Tape of your…

Pobrania
1
Polubienia
1
Ocena
0

3D Printed Case for a Handwired Gherkin 30% Keyboard

To build this model, you will need A soldering iron, flux, and solder Copper wire (I recommend ~16-18 AWG. I tried using 10 AWG to give the board more heft, but it was a bit too cramped in such a small case) Insulated signal wire (I…

Pobrania
0
Polubienia
2
Ocena
0

To wszystkie aktualnie dostępne wyniki.