Liczymy pasujące modele…
The original was simply too small for me: Requires 3x M3 12mm, 1x rubber band as gasket, use diamond or snake knot for the paracord ends, if you like the original paracord end base and cap you can grab it from the original. Gasket is…
Mini tripod, comes in 3 leg heights (85, 100, 120mm) . Rotate ring to adjust height/leg spread Requires: 3 - M3 16mm socket head screw 1 - ¼ ½ inch bolt Optional: Foam sheet to improve grip when handheld or reduce slipping, use cutting…
These are small pieces with fine details, ensure that your extruder is properly calibrated for best results Printing: 1) Ideally, 0.3 nozzle or finer, if using a 0.4 nozzle set line width to 0.33 (or thinner if possible), I printed mine…
UPDATE 2026/07/02: Consider this instead: I find the original a bit tight/tough to dispense all cards in the stack, also there's not enough space to identify and pick a card. My solution, dispense half the stack on one side. I have to…
Updated: 21 June 2024 Thinner version at 1.4mm, 12 slots At only 1.4mm thick, this microSD card holder securely holds up to 12 cards, easily stacks with other cards in your wallet or card holder. Optimized with the following print…
This phone holder can be mounted to a tripod/monopod/selfie stick with a standard ¼ UNC screw. Phone can be oriented in portrait or landscape mode and can be tilted as well. base-wide allows for holding up to a 90mm wide phone (if there's…
Case for 20 king size cigarettes with magnetic Zippo slot. Note: Zippo cases are made of brass and therefore non-magnetic, the fluid insert is magnetic, might not work for butane inserts. Use 15 6mm diameter by 1mm thick neodymium magnets
Zippo case designed for FDM printing with sturdy (enough) hinge. Use filament as hinge pin. Different designs available, will be adding more. Note: snug fit, for best result/fit calibrate printer for precision (extrusion, skew precise…
Updates: 2026/07/10 : uploaded plain side versions of body and 9 card version Features: 1) Slide lock to secure cards in place 2) Excellent latching to hold cards in place when dispensing 3) Built-in hole for paracord, etc. 4)…
Prints flat, requires bending. Material : PETG Supports : Yes Post processing: 1) Use hot water to bend, PETG bends at around 80C, using heat gun for me is difficult to control. 2) Use broken arm as mold to get correct shape, use clothes…
Case for iPod Classics versions 5 and 6 thin versions only. With rubberband slots at the back for stacking. Use PETG.
Update 2025/10/15: Modified reset switch opening, not sure if it's the switch I got but switch protrudes considerably from PCB edge affecting alignment with holes. BLE power switch ON marker Modified to use the more common M3 heat sets…
Thorzone Mjolnir inspired case. Case is held together and reinforced by threaded rods providing the needed stiffness and structural integrity Most parts prints flat and only a couple needs minimal supports. Black parts are printed with…
To wszystkie aktualnie dostępne wyniki.
