Liczymy pasujące modele…
I assembled an enclosure for my 3D printer and wanted to lead the toxic exhaust out of the house. I intended benefit from... a large fan for its power and potential of running more silent than a smaller fan smaller diameter tubes rather…
3 pieces that are easy to print with the flat side down. The thin one is rather optional and only fills a small gap. It can be easily glued to the front frame. The back piece can be clipped on and serves two purposes. It closes the rather…
The lid is designed with two circular cut-outs and according caps (plugs). This allows you to lead cables through it or close the holes if you don't. The plugs snap easily into place and can be easily removed again. Due to its size it's…
After designing the frame for the Galaxy S9 I also acquired an S9+ and made this one. The S9+ has an even better fit for the GameSir X2, since its size is more maxed out. (See the design for the S9:…
Hint for printing: Use some kind of support for the flat surface on the inside of the cap - at least around the hole in the center. Else the hole will not come out clean (main tunnel for the grease).
The stand consists of two holders and a connector. Using the connector is optional, it only keeps the two holders in position. If you use it, make sure to tilt it slightly so you don't see it through the hexagonal hole of the holder, then…
This clamp is specifically designed to fit “OBI Santos” boxes and their lids. Also, they allow some clearance so a stripe of sealing tape (e.g. foam tape) can be applied on the outer edge of the lid. Depending on the material (PLA, ABS,…
To wszystkie aktualnie dostępne wyniki.
