Liczymy pasujące modele…
This is a vertical laptop stand for the Framework 13 laptop when the lid is closed. I designed this model based on the CAD files provided by Framework, so the laptop should fit snugly into the stand. According to Framework , it should be…
This is a cable organizer for the Nintendo Wii PSU. The model is sort of like a sleeve that you slid onto the PSU. Then it has groves on one of the sides for the cable that goes into the Wii console. You can fit the whole cable length…
Case to Waveshares Ethernet / USB hub hat for raspberry Pi. No screws needed. Link to the hub: https://www.waveshare.com/eth-usb-hub-hat.htm SKU: 16595
Hanger that I created for Ikeas LILLNAGGEN squeegee. This hanger fits shower doors that are up to 6.5 mm thick. You will need to enable supports to print this model.
A very simple hanger or hook that fits the FISKBO frame clip or other models with similar clip from IKEA. Just put on double-sided adhesive tape to attach it to something. Do not forget to clean the area where you attach it (the wall for…
A tablet stand designed to be used in your lap/knee (but can be used on a table as well). The stand can be angled at 30 or 60 depending on orientation. Fits tablets up to 265 mm long and 10 mm thick. The stand is 200 mm wide. I used 15 %…
Front mount for the Raspberry Pi Pico on the GameCube. I designed this to be used for the PicoBoot modification. The model consist of three parts which can be printed individually: The first part is a hanger that is attached to the USB…
This is a cable organizer for the Gamecube PSU. The model is sort of like a sleeve that you slid onto the PSU. Then it has groves on one of the sides for the cable that goes into the Wii console. You can fit the whole cable length into…
I designed a toolboard mount for my Voron 0 to address some limitations I found in the Universal Mount for the NH36 toolboard when using the Sherpa Micro extruder. Some advantages compared to the universal mount: Does not interfere with…
I designed this custom bracket to mount the Ikea KOPPLA 6-outlet power strip (model E1654-EU6WSW) when the surface wasn’t wide enough for a typical end-mount design. This model features screw holes positioned one outlet in from the ends.…
This is a cable organizer for the Nintendo Wii U PSU and the gamepad PSU. The models are sort of like a sleeve that you slid onto the PSUs. Then it has groves on one of the sides for the cable that goes into the Wii U console and gamepad.…
This case is designed to be used for the ESPSomfy RTS controller and is compatible with the following components: Transceiver https://www.cdebyte.com/products/E07-M1101D-SMA/7 Seeed Studio XIAO ESP32-S3…
This is a case for DFRobots Raspberry Pi Compute Module 4 IoT Router Carrier Board Mini split into two parts; top and bottom. The case is held together without using any screws. Link to dfrobot website:…
I was asked to replicate the bright yellow/green adapter in the cover photo. It is a adapter/connector to join together a frame for a Stiga goal. Not sure if it is a football or floorball goal but I think it is some kids variant atleast.…
To wszystkie aktualnie dostępne wyniki.
