Liczymy pasujące modele…
3D Printed stencil for spray painting flammable logo on boxes and containers. My models are not to be shared on any 3D Model website that requires the user to create and use an account to access models. I.E. the model is NEVER to be…
Designed in TinkerCAD to mount on 1/8" (4mm) holes x 1" (25.4mm) spacing pegboard. There are two versions. The attached photos show version 1.0. Version 2.0 has a bit more support on the back. I print with supports but only to support the…
Prints flat with no supports needed
A simple 180mm x 90mm x 60mm utility tray. I designed it to fit two on the bottom shelf of my medicine cabinet but the tray can be used anywhere. The holes make it easy to see what's in each tray but also makes it easy to pull the tray…
This tread stand replaces the little rod on the CLSP for holding your tread spools. The stand is assembled with superglue and once installed (you'll need a suitable bolt and a couple of nuts) it also feeds the thread from a proper height.…
I use Evapo-Rust often to remove rust from parts and tools. This is a small basket (it has to fit in the opening of a narrow mount Mason Jar) is for washing small parts and tools. The tall Mason Jar is from a bottle of pasta sauce which…
I needed to clean up/fix a couple of holes in my bathroom wall where I used to have a towel rack. The holes were larger than just a small screw hole as I had used screw in anchor nuts. Also since the holes were through existing wall paper…
A small simple box for utility storage but sized for storing 50 rounds of .40S&W ammunition. Makes for a great utility storage box as well. No supports required. The sliding lid design was copied and modified from this model:…
I use these tags on all my fuel/propane containers. I manually turn the indicator dial as I use the container and I can tell their status at a glance, even across a crowded garage. Be careful when gluing on the knob so that you do not…
Two part screw on tag as a base for labeling .30 cal ammo cans. I use PLA but any filament should work fine. Add identification information to the tag with a label maker or a stencil or even a Sharpie or similar marker. My models, or…
I have to manually change filaments to get multicolour. If your printer can print with multiple filaments, you'll have to figure out how to make that work on your printer.
I shortened the original hook using TinkerCad. The original was a bit longer than I wanted. The shorter version has the same size loops, just a shorter connecting arm.
My small belt/disk bench top sander has two ports for connecting a shop vacuum. Neither port is the correct size for the small hose on my shop vacuum so I designed and printed suitable hose attachments. At the same time I designed these…
To wszystkie aktualnie dostępne wyniki.
