Liczymy pasujące modele…
My cheap Winsinn fans make a pretty terrible rattling sound when printing at accelerations over 5k. This eliminates most of the rattling sound by pushing the fan against the hub. The pressure on the hub can be adjusted by sliding the…
Warning: Read all instructions prior to installation, especially the part about the screw length! A remixed nozzle for the Double 5015 fan mod for significantly less back pressure and greatly improved cooling. I liked the original nozzle,…
This is a bumper for the center console on the 96-98 Jeep Grand Cherokee ZJs. I printed mine in Polymaker 95A TPU. I recommend cleaning up the old holes with a 10mm drill bit by hand (not in a drill!) and/or blade and/or wire cutters. One…
The long one is for the top of the 2 500mm (700mm on the plus) front extrusions to create holes for the blind joints that attach to the 3 extrusions that run rearward on each side The medium sized one is for the back of the Y axis where…
This is a larger design of LM8UU extractor for the SV06 that is designed to fit LM10UU style bearings. I recommend triangle infill. Instructions from original post: Print Settings Layer height 0.2mm Sturdier settings, e.g. 1.2mm walls and…
The old watering can nozzle cracked after being in the sun for too long. I printed this one to replace it and have a more even pattern. I also minimized internal volume to minimize drippage. Print large flat side down.
Use a high temperature, possibly flexable filament. I used YXPolyer PA6 (no fibers). I suppose you could try a fairly stiff TPU, and could also try ASA/ABS, but I'm not sure how they'd hold up to the heat. See below for support sections.…
This mount tucks the probe as close to the nozzle as possible. SV06 style and SV06+ w/Volcano nozzle options. Below are my settings in Printer.cfg [bltouch] sensor_pin: ^PB1 control_pin: PB0 x_offset: 24.0 y_offset: -25.9 pin_move_time:…
My toddler stole my old knobs, so I made a made these replacements. Printed in Polymaker Polysilk Silver with Octagram Spiral surface pattern
I'm not sure where I got these stools, but the end caps kept falling out. I made this model to screw in and latch on to a bolt sticking up inside of the handle. The outer diameter of the screw on section is about 32mm. The inner diameter…
To wszystkie aktualnie dostępne wyniki.
