Liczymy pasujące modele…
Pretty straight forward print for the most part. I used PETG since my garage can get hot in the summer, but there is no reason this can't be PLA if temperature is not an issue. Bit Rack - this is the back plate and needs no support Bit…
UPDATE: for the lower pulley, I turned the strap 90 degrees so that the rope does not twist. I also uploaded the 3 print file g codes that will print all the parts nessesary in PETG. I wanted to have a few of these Pulley lifts as I have…
Used TPU so solve the problem of not enough grommets that came with a new frame. This could potentially work for other frames if it is scaled up or down in the slicer.
Easy 5 minute print!
quick print that costs about 20cents in PLA. best to print on its side and support the pin that connects to the toothbrush head for max strength. I made the fit tight, took 20 seconds of sanding on the supported part to get a nice tight…
designed to work with generic 1" grid pegboard (¼" holes). I used PETG to make sure that the clips had a little flexibility and my garage gets hot in the summer. The pins will need to be glued in the back, be sure that the curved pins are…
I printed this out of PETG with 30% infill and 4 perimeters for extra strength and it has lasted months (longer than the original part did)
I had an old magsafe wallet and decided to not let the magnets go to waste. I made this mount for my indoor trainer bike that I use in the winter. This should be compatible with most bikes out there as long as the stem is longer than 50mm…
The feature on the bottom fits into the groove for the volume slider and creates a hard stop so that the max volume can only be set to 50% or so. Potentially needs to be glued on as my 4 year old has figured out if he pulls it off and…
To wszystkie aktualnie dostępne wyniki.
