Liczymy pasujące modele…
I have tried many y-axis bearing holders and never could find one that performed well. The MK3s U-bolts were too finicky to tighten just right and inevitably lead to the bed getting loose and rattling. The MK3s+ metal straps and many…
I service my hotend a lot and have plugs for the heater and thermistor close to the extruder body. Having a "quick release clip" that holds everything neatly in bounds for proper x-axis movement was a huge step forward. Heavily inspired…
This adapter screws on the back of the Core One with (4) M3x10 screws, makes a good seal, and has a 20mm plenum area between the fans and filter to ensure the exhaust air can spread over the entire filter surface area. The Tesla Model 3/Y…
*Now updated to include cable management and built-in support for easy printing I prefer to remove the entire extruder heater assembly for maintenance, such as replacing nozzles or fitting a silicone sock. To do that, the heater and…
One of the force multipliers to successfully use gridfinity is the ability to make lots of boxes quickly with vase mode. All the multiple unit models I could find required printing the base of the box separately and gluing on later to be…
This knob enables the bowden fitting to be easily unscrewed from the Core One Nextruder. It stays in place by clipping onto the bottom of the bowden bend. No need for a wrench, the large surface is easily gripped with fingers. This knob…
As everyone knows, the extruder motor on the Prusa i3 runs hot. I wanted to add heat sinks, but have heard of the thermal adhesive not sticking long and them falling off. This heatsink clamp adds compression to the two side heatsinks,…
This was designed to replace the factory supplied horizontal stabilizer tips on a Rans S-21 kit aircraft. No supports required, internal geometry optimized for low weight and strength. Match drill the factory skin holes to this, glue…
The original hex bit holder is excellent, with the springing retainer, and tight fit. But, some smaller or slippery bits can be tough to get out. The addition of a hole at the bottom allows them to be poked out with a hex key, nail, or…
This slips over the tang on the cage of a Rans S-21 and adds lower guides to ensure the aileron cable stays in the groove on the small pulley below the seats. The little hole allows for an AN3-7A bolt. The big hole is to reduce material.
These hold the factory bushings with additional hardware to keep them aligned, reducing friction and providing a more secure pedal feel.
To wszystkie aktualnie dostępne wyniki.
