Liczymy pasujące modele…
This is a simple remix of the USB organizer by Honza200 Removed 1 SD card slot and 1 USB A port Added 1 USB C port Added a Gridfinity base with no screw holes
This is a screw on adapter for the Yeti Colster 2.0. It adapts to fit a 16oz can. This ONLY fits the new 1/4 turn thread-on cap design. Edit 2023-02-12: Added an extended version to fit 19oz cans based off of another users suggested…
Based off of RIP_Plo-koon's design. I wanted to quickly change parameters and generate my own sizes in Solidworks. I left out the screw holes because I don't find them that useful.
A simple remix to make the model easier to print. I removed the overhangs so it can print flat on the bed without support. I printed in PETG and it fits like a glove. Thanks Noctua !
This is a remix of a model I published on thingiverse. I made this version a little wider. Print two and add a little bit of sticky rubber to the bottom to keep them from sliding. They should fit pretty well, depending on your printers…
Gridfinity Holder for 16 CR1220 batteries. 1x1x3u. Stackable
Snap fit case for deej audio controller. Designed to fit three slide pots with 45mm of travel and an arduino nano. See the deej github for the software and build instructions: github.com/omriharel/deej PARTS LIST 1X Elegoo arduino nano…
I designed this rim and tire combo to replace the wheels on a strider bike for children with smaller legs. This wheel is approximately 8" in diameter (200mm actually) The rim I printed with PETG and requires supports. I used 4 perimeters…
Gridfinity Holder for 12 CR927 batteries. 1x1x3u. Stackable
I wanted to add some better lights to my Sovol Zero but wanted to reuse the holes already in the frame. Each side requires two M3 heat-set inserts. I printed them out of black ASA and they fit on the zero bed. I used these lights:…
Motivation I wanted a way to draw heated chamber air for the auxiliary part fan instead of cool external air. There is not much space to work with but I managed to fit in a new fan intake that uses the existing fan screws. Printing I…
Design for a baby bouncer toy bar. Modelled after the Baby Bjorn version. A little more involved than just printing but worth it in the end. Materials needed 20in or 500mm of 0.1875in or 5mm steel round bar Two printed end caps Two…
Display your Edge 530 on your desk. Haven't tested with other computers but it might work for them too.
I liked Shiro321's idea but wanted to make some changes so I designed my own version. This design uses an M3 nylon lock nut and a M3x20 socket head cap screw. There are two versions of the clamp. Best bet is to start with the normal…
Designed for 2X 12x3mm magnets. Magnets designed to be added after printing and to be held in place by mounting the clip on a strap and the hose side on a hose. Designed for an 11.5mm hose Will fit a strap up to 20mm wide I printed in ASA…
To wszystkie aktualnie dostępne wyniki.
