Liczymy pasujące modele…
Requirements 4x standard 0.1 inch pin headers for male connectors 4x standard 0.1 inch socket header for female connectors Print with PETG for better flexibility 0.3mm nozzle or finer will give good results
This is a mount for the Honeycomb Storage Wall I wasn't happy with the existing screwdriver holders (too blocky / squary or unpractical in tight spaces), so I made my own model :) You'll need an empty insert to mount it
Models These models are for the G502 Proteus Spectrum (model from 2017). There are many revisions of the G502 mouse that are very similar in design, so there's no guarantee that this model will be compatible with your G502 mouse.…
I changed the dimensions of the clipping part to be more easily inserted / removed on the Ender 3 S1 Pro, since you need to remove the feet in order to remove the back panel. The original model was bending too much and could not be…
Post processing Depending on your printer settings, you may need to file the underside of the ball, and remove blobs on the top of the inside of the ball socket To insert the ball into the socket: Soften the socket by slightly heating it…
Long version that can hold up to 8 ethernet cables (4-7mm), and cables stays inside the slots when the clip is opened
The mount is quite rigid, and the screen fits tightly when pushed down and will not move. Printed in PLA
This is a mechanical door stopper that can be operated with the foot. The locker part (in black) can be switched between two positions: pushed down to block the door, pulled up to release the door. Requirements A gap of at least 7mm…
By default, the filter is placed very close to the panel, reducing airflow and increasing noise. This spacer mounts on the existing pins/slots without requiring any glue / adhesive, and adds 6mm of clearance. The model is actually split…
Mounting You will need to route the BLTouch cable to the back of the print head, on the PCB. I advise to tape the cable on the PCB to avoid mashing the cable between the PCB and the printer mount. Mount the BLTouch using 2 M3 screws (same…
The mainboard / motherboard fan mount is 6mm high and can be installed with the standard printer feet. The PSU fan mount is 11mm high and requires higher printer feet (I used these ). Installing the fans requires cutting holes inside the…
Rear paddles for the KingKong 3 gamepad from Gulikit There are two models for the 4 paddles. Each model needs to be duplicated and mirrored along the X or Y axis to get 4 paddles. The shorter paddle is used for the upper paddles (G1 & G3)…
can only hold pens owned by a true physicist
This mount replaces the existing CR-touch shell to mount the probe as close as possible to the nozzle (and saves a few grams). Best printed in PETG or other filaments with little warping on temperature change The probe doesn't collide…
sorry I had to remove the logo in order to move the magnet as close as possible to the bottom of the cap
Print instructions Print the camera bump separately, and glue it to the case Print the first layers in PLA, change to TPU for the last 2 layers of the bottom plate. The two materials bond very well and can't be separated (eSUN PLA+ and…
battery-switch This battery cover lets you completely shut down the caliper, to improve battery life. By default, the caliper always tracks its position even when powered off, and the battery only lasts a few months. The mod reuses the…
Requirements Blue and white PLA. I used eSUN PLA+ AV Blue, but any deep blue filament should work. PETG should work too, and might be more translucent than PLA. White LED strips, ideally those that looks like neons with lots of tiny LEDs,…
To wszystkie aktualnie dostępne wyniki.
