Liczymy pasujące modele…
34 Different thumbscrews / bolt knobs for 17 different fasteners. Refer to the following table for sizing. Spacer height refers to the distance between the bottom of the fastener and the bottom of the knob. Can't find what you need? You…
This is a complete set of STLs and OpenSCAD source files to build an animatronic tail. The scripts and source files are licensed for non-commercial use, please keep this in mind if you plan to make one for yourself. This tail consists of…
This is a procedural bracket that can be used to affix a D Ring to many different surfaces. It can be customized for a variety of different screws and D Rings and has been specifically designed to be concealed on the underside of…
Something resembling 1515 extrusion. Most parameters are customizable, including length. Category: 3D Printer Parts
A fully parametric, user-customizeable louvred vent to keep you cool (and well ventilated)! Most design parameters are fully user customizable using the OpenSCAD customizer (Window > Customizer). Almost any design parameter including the…
50mm to 80mm fan adaptor. I originally designed this to adapt an 80mm case fan to fit onto a Slot 1 CPU heatsink, but it will likely work in other applications. This has not been tested, so if you do print one, please post a make!…
Oops! I've made too many brackets! You can help by downloading some. A huge selection of brackets ranging from 15-75mm in many different variations for M3-M6 and #4-#8 screws. SCAD source included so that you can make your own as well.…
This is a compact device designed to dry out fursuit heads or other similar masks. The fursuit head fits over the supports in the center of the unit and a fan located under the unit circulates air through it. This device has been designed…
I challenged myself to create a customizeable cable tie anchor in OpenSCAD in under 10 minutes after seeing a few designs here that didn't quite fit my needs. This was the result of that challenge, with a few small added improvements to…
An exterior corner for 1515 extrusion. This corner does not place the two ends of the extrusion directly beside each other and will effectively add approximately 2mm to each piece of extrusion. Category: 3D Printer Parts
This is a bracket that will allow you to mount a standard ATX power supply to the Geeetech i3 ProB. Requires: 4x M4x16 Screws 4x M4 Washers 4x M4 Nuts 3x 6/32 computer case screws Zipties (optional, for added stability) Print Settings…
Posted to Printables by cudatox. This is a mounting adapter to mount a webcam to a cheap USB powered LED ring light. I use this for streaming traditional drawing. I sized this for my particular webcam and LED lamp, but yours may differ in…
Designed to be secured to a surface using 1" / 25mm two sided tape or hook and loop.
To wszystkie aktualnie dostępne wyniki.
