Liczymy pasujące modele…
While trying out Sony hot shoe covers for my A6700, I wanted to test out making them out of some of the Proto Pasta Copperfill PLA that I had on hand, and then sanding it smooth to bring out as much of the copper shine as possible as an…
I wanted a lightweight way to keep some cables organized in my Aer Travel Pack 3 Small. The front pocket is convenient but has no other internal management features so I designed this panel to hold all the cables in place to avoid…
This is a case for the Xiaomi Wowstick SD, which seems to be less popular than the more common Wowstick 1F series. I had chosen the SD over the 1F because I wanted more torque to be able to drive screws into prints and because it is…
This is a simple holder meant to hold a label on the exterior of a Fellow Atmos coffee container. I found that at times I would lose track of which beans I had in which container, especially if I ended up being away for a bit without…
Wall plaque of the Kiryu-kai logo. The plaque is 175x175x5 mm so it should print on most printers, I printed it on my Prusa Mini. Color change should be inserted at 3.2 mm if you want. The original button is 65x65x2.6 mm and has a small…
I wanted to mount a Dragon hotend on the CoreXY I was building with the Orbiter extruder above it, neither of which are standard for that design, so I used this base as a foundation to design a platform to mount the Orbiter. The platform…
I really liked the design of these boxes but found that the tissue boxes I use from Costco are too tall for the original design. So I made both the lid and base plates taller and cut recessed areas into them in order to fit the boxes…
I bought an SK Cube kit but was interested in building my own toolhead, in part to use components I already had on hand (Orbiter 1.0, Dragon hotend, EBB42 Canbus board) and to improve cooling since I print a lot of PLA. I also wanted to…
These feet were inspired by 247printing's wider feet for the Voron V0 to improve stability. These mounts move the feet outside the edge of the motion system of the printer, which should improve stability when printing at high speeds. I…
A simple holder for the GamersNexus collectible coasters. There are versions for 4 coasters and 8 coasters. Does not require any special print settings or supports. The holder in the photos is printed from Proto Pasta Blue Wonder and…
I really liked the design of JVCB's slim filter case and wanted to use it for the Haida 67 mm CPL/VND. The diameter fit within the case as did the adjustment knob, but it needed adjustment to thicken the case body. After printing the…
This is a remix of JackJack3231's 120 mm Voron V0 Auxiliary Fan Duct to support the SecKit SK Cube. It has been adapted to attach to the Y-axis rails using M3 screws and M3 heat-set inserts. Based on tests, these should clear all of the…
These brackets slide into the M5 screw holes in the motor mounts to position a fan directly below the X/Y motors on the Layerfused X301. I found that my motors were getting fairly warm despite the heatsinks and wanted to address the…
To wszystkie aktualnie dostępne wyniki.
