Liczymy pasujące modele…
I recreated the model in PTC Creo and changed it to allow thinner stock and full access for marking out the pins. The idea is based on the “Shawn shim” Rob Cosman uses, by offsetting the parts when marking out pins from tails, by the…
This is a ring to mount a Copal 0 (or similarly sized lens/shutter combo) to one of the M65x1 focusing helicoids. Did not think 3d printing such fine metric thread would work, but it does. Printed with 0.2mm layers, and a 0.6mm nozzle…
Ok, here goes. This is a wooden box (I used dovetails and mahogany), with a largeformat lens mounted on the front, on a custom sized lensboard which has a (Aliexpress) m65x1 focusing helicoid. Depending on the focal length one needs a…
2x2 block for the Bauhaus desk organiser with cutout for a Baseus wireless charger. Top of the charger sits 1mm proud. It has the rectangular cutouts in the bottom, and I assume in the right location, but I am not using the clips myself,…
I used steep chamfers so the model prints without supports. Made the snap fingers a hair smaller in diameter, because the originals were very tight, these still are also plenty tight.
A friend of ours, with quite a few very long solo bikepacking trips under her belt, mentioned that she is using a stand which also works with loaded bikes. I checked it out and at first I did not believe that something so simple could…
This is a recessed lens panel for Sinar and Horseman technical cameras, made out of 3mm MDF. I am using black through coloured MDF, but you can certainly paint it afterward (maybe even helps to cover up small gaps). The panel is recessed…
When having luggage in the middle of the bike luggagerack (rather than just panniers) mounting the Garmin Varia rear light to the seatpost does not work well as it is not able to "see" over the mounted luggage. Designed a reduction collet…
To wszystkie aktualnie dostępne wyniki.
