Liczymy pasujące modele…
These feet allow you to attach anything you want onto your Milwaukee packout toolbox. Post-Printing To help the bolts thread through the parts easier, I drilled out the holes with a 6.5mm drill bit. How I Designed This I've decided to go…
UPDATE: These have been updated with bigger font. After a while of going to print, test, adjust and print again I got sick of that method and finally decided to print a fillet gauge to be able to get the fillet radius. In the past I used…
Over the years I would end up dropping the remote a few times, in doing so the battery cover ended up breaking so for a long time I was using tape to hold the battery in, I then got an AnyCubic Photo Mono. From using tape to hold the…
After recently buying a Bose QuietComfort 2 earbuds . The only downside I found with them was (as lazy as it is) having to plug them in to charge them, as apposed to just placing them down on a wireless charging pad having to just use one…
After upgrading a few lights on my car which mind you is a Holden VE with a Pontiac G8 front conversion. Months after posting this I've noticed Mars Performance (Melbourne, Australia) no longer sell these fog lights... however they do…
The whole idea of this was because our panel saw at work had a loose USB plug which kept disconnecting so I made this to hole it in tight. How I Designed This The USB port on the saw had a similar setup as seen on the VGA port below, with…
When organising my workstation I made this hook for my alligator leads. How I Designed This There is 20mm from the arch to the top of the stopper and with a 43mm radius.
With my job we're required to cut power points into our products, I quickly got sick of having to use the paper power point cut out, so I figured a 3D printed template will be more reliable and less flimsy. How I Designed This I've added…
Upon installing the Viper 509u I wasn't too fond of the look and if they were knocked they would have to be readjusted. Along with keeping up the appearance of my vehicle I was wanting something a bit neater then the provided bracket, so…
The whole idea behind this print was to stop my drill bits/impact bits from falling into the other compartments, I would open the lid on my drill case and find a heap of my smaller drill bits would fall into the back compartment making me…
Upon setting my house up with Philips Hue smart bulbs I wanted to retain the existing way to turn the bulbs on/off. I didn't want to buy the Philips Hue buttons due to it's lack of automations outside of the Philips Hue eco-system, so I…
For my job one of our clients wanted an in-drawer powerpoint and decided to go with this this in-drawer powerpoint. Now the whole reason I even wanted to make this jig is because the cut-out has to be really tight (as mentioned below). So…
To wszystkie aktualnie dostępne wyniki.
