Liczymy pasujące modele…
Designed for using Heat Inserts on the 4 holes where the Lid gets screwed on. Can hold 2x XT30 connectors. Update v2: added clearance to lid for the lid to fit easier closed some holes, as v1 exposed wiring.
Overview Designed with precision and robustness in mind, this protective case is specifically tailored for the BTF-Lighting A24V10A PSU and controller. Its hefty structure, with 1cm thick walls, ensures unparalleled protection for your…
This is a base for the end of the BTF-200-12 (12V, 16.5A) version of this power supply: https://www.aliexpress.com/item/32670477391.html It covers the end with the terminals to hold the supply upright (like a Wii). There are internal…
8m topo model of Doubtful Sound, Fiordland, New Zealand. From LINZ geo-tiff data. Sourced from the LINZ Data Service http://data.linz.govt.nz/layer/772-nz-primary-parcels and licensed by LINZ for re-use under the Creative Commons…
Simple panel-mount connector for the generic 2-pin, 3-pin, 4-pin, 5-pin, or 6-pin Big connectors by BTF-LIGHTING sold on Amazon here: https://www.amazon.com/gp/product/B01LCV8LVK/ They use the same outside shell for the 2-pin and the…
Cap for BTF Lighting 3 pin connectors with 18AWG wire big size
I use these with my xlights display if I have an exposed pigtail end or if I'm wrapping up for the season and I've not had a chance to pull down a prop. Specific pigtails: BTF-LIGHTING 2 Pin Electrical Connector 22AWG IP65 Male Female…
A mount for a BTF-LIGHTING Tuya Zigbee 3.0 C05Z Strip Controller. Several different products use the same case design. The one we used was https://a.co/d/azX1DJ5 It uses a 3mm screw or bolt and is designed to accommodate a heat-set…
Replacement buttons designed for the BTF RB wall-mounted remote control.
A small open-front holder for the RD4 2.4G RF LED remote. It holds only the bottom of the remote, so most of the face stays clear, and the buttons work while it's docked. Which remote This remote comes with LED strip kits and controllers…
I remixed the original to fit the BTF 14Keys remote. The remote fits snugly into the holder and is mounted using two 10x3mm magnets. The magnet holes are also made smaller for the BTF version. Printed in PETG, 0.15mm layer height, 0.4mm…
Replacement buttons designed for the BTF RB wall-mounted remote control.
