10 modeli
Introduction This robust tripod mount for the FP3 can be used in landscape and portrait orientation. It is intended to be used with the FP3 bumper in place, allowing access to all connectors and buttons while in use. The frame can take…
Wydruk około 1,53 €–1,87 € nettoWstępna wycena jednego wariantu
Drop in Corner Mount for Aqara FP300 Hex cutouts in the back reduce resin required by ~20%
Simple mounts for the Aqara FP300. I’ve included STEP files so you can easily modify them. Stand: Simple stand for flat surfaces. Clip: A clip with a 4.85mm gap which fits my cabinet door. You will likely need to adjust the STEP file to…
Many DIY microcontroller projects require to program / flash the uC (e.g. with a bootloader) before it is useable in the circuit. Smaller PCB often don't give the chance to access the uC chip at its ISP pins for flashing easily, so the…
I needed a mount for the Aqara FP300 Presence Sensor. I didn't like the existing ones out there; some are drop-in mounts, but since the base of the sensor has two magnets, I wanted to use them. This corner mount requires two magnets with…
This lets you mount your Fairphone 3 (FP3) in your car snapping onto an existing car mount. There are two versions, depending on if you intend to use the rear facing camera or not. Print Settings Rafts: No Supports: Yes Resolution: 0.15…
I shrunk the model a bit and got a box for TQFP32
Mount your Aqara FP300 presence sensor in a room using your existing IKEA VIDGA curtain rails. Slide it the VIDGA rails sideways and then turn 90° to lock it in. No need to remove the curtains. Mount the sensor itself by unscrewing it…
Drop in Corner Mount for Aqara FP300 Hex cutouts in the back reduce resin required by ~20%
