Liczymy pasujące modele…
This is a small box to hold an ESP32-Wroom32 micro controller, a level shifter and a female power plug. It uses M2 screws. Can be printed without any supports. Used Parts: These are just examples, not recommendations. The parts are…
This is a remix of the excellent Yoradio case design. My version is 12mm shorter and slightly easier to build. BOM: ESP32 Wroom with 38 pins and a wired WiFi antenna SSD1322 display ESP32 expansion board rotary encoder PCM5102 DAC…
Designed for vertical use Printed with Prusament PLA Prusa Galaxy Black Layer height 0.2mm on Prusa MK4
A rather large box made for a wroom32 ESP32 dev board together with a 1.8 inch TFT display at 128x160 pixels. The box is big enough to use breadboard cables to connect the screen to the ESP. Grooves for miroswitches 6x6mm on the sides.…
This is a parametric tray for doing pick and place with ESP-WROOM32 modules. The design is done in CadQuery, and sorry that the code is super sloppy, but I thought it was better to just provide it. Note that as built this is nominally for…
You need: Screws M2 6mm 7ps Brass insert nuts M2 5мм 7ps Github: https://github.com/tuxamat/watermeter/tree/main
NEXX X-COM to Cardo Intercom Helmet Mount Adapter Upgrade your motorcycle ride with this custom 3D-printed adapter designed to mount your Cardo Intercom system seamlessly into the native NEXX X-COM port of your helmet. Instead of relying…
"Japanese Erasers" are very popular with kids, as are keychains that hang in bunches on the outside of backpacks. I find both, though the erasers in particular, to be excellent 3D learning tools. When taken apart they're reduced to basic…
print 2x. Threaded holes sized for M4(0.7)x20 bolts to make tapping easier. Must be tapped though or you'll have a bad time. Print sideways on its edge for maximum strength with some post work required, standing on its end (default) for…
Make sure supports are enabled ("tree" type work best for this). Should be scaled up, I recommend from 100% to 2000%, or higher. The resolution of the model will still work at this scale.
Hi, Im currently running OM3 10G fibres around my house and wanted a clip to run them through. I Made these models to support the thinner patch leads (about 2.2mm) and the larger ones (around 3.2mm). The covers clip over the screw holes…
