9 modeli
To be fair, this fan shroud barely improves the partcooling. On some prints there was a slight improvement, on other prints it was exactly the same result. I think with a more powerful partcooling fan like the GDSTime 12000 RPM Fan it…
This is a mod of the reindeer fanshroud to enable use of volcano length hotends like the K1 ceramic heater hotend. It could also work with other, not as long but longer than stock hotends, I haven't tested that though. I modded the…
I used an NMB-MAT Model: BG0903B057-P0s but as this fan was salvaged from old electronics you will maybe need to search a little bit. Fan dimensions are ~33x58mm
I used to run the shroud linked below and it's great but i never liked the bulkiness and that one fan covered the nozzle. This is also easy to print compared to other solutions.…
this is a template I made to build your own fan duct for part cooling
New version is easier to assemble and a bit more plastic to remove the creep issue I faced after about 100 hours of printing. Install: 0. Install heat inserts if used into towers. install 2 nuts into holes for the sideways30x30 fan…
UPDATE: I'll do not recommend this design when printing over 60mm/s. Check out my other things for better cooling. Just extended the fins to the bottom for easyer print. Thank you @7effrey for the volcano modification! Category: 3D…
Fan holder to go with Openscad X-carriage wilson style
The backplate has mounting points for a cable tower and uses heatset insets. If you need modification text me.
