Liczymy pasujące modele…
Here is a fan duct with dual part cooling for the Ender 3 (Pro). "Unibody" version For the assembly you need: 1x 3510 fan 2x 3010 blower fans 2x M3x6 screws 1x M3x12 screw Assembly: First insert all fans into their places (M2 screws for…
Here is a "unibody" remix of my previously designed fan duct with dual part cooling for the Ender 3 (Pro). For the assembly you need: 1x 3510 fan 2x 3010 blower fans 1x M3x12 screw 2x M2x5 or M2.5x5 screws (minimum) Assembly: First insert…
I needed to get some grease into the differentials of my RC model car, so I remixed @Alexey's original design into a nozzle with a single opening of 3 mm diameter. See also the original model including a cap . Printing PETG, 0.4 mm…
print with ABS or ASA M3 screw to mount bltouch and fan
Original Side_Logo_Insert was only for 4010 fans. For 3510 is not usable so I remixed it to fit into 3510 side skirt.
Hallo, ich brauche einen Wandhalter für einen Switch also eben einen In Fusion erstellt. Er hat 0.2 Toleranz und kann liegend mit Support oder Hochkant gedruckt werden. Er passt eben so auf das Druckbett vom Mk3s+ damit das geht musste…
Removed mounting Bltouch mounting pad. I am using separate bltouch holder which is mouted to the holes on H2 V2S extruder. See the link below. https://www.printables.com/model/727678-biqu-h2-v2s-bltouch-holder
Update 24/7-18 Needed better cooling and lower mass on the X-axis. Decided to make nozzles that press fit into the opening of the fan, this works a lot better than the previous design. Not as clean looking but that might be revised in the…
Measurements taken by hand, a tolerance margin to allow for the creation of a case for the PhilipsXPrintables contest & for concrete modeling supports or enclosures (waiting for a working printer and time!) .Step = BowTie Case for hc3510…
Deckel für Milchshaker als Spritzschutz.
An adapter that fits my BIQU extruder. Its hard to find 3510, 24V fan for my BIQU. They are often also very loud. This model makes it possible to use a 4010 fan for the heatbreak. The model also has a place for 3dtouch. Use M3 inserts for…
Einfaches Lüftergitter-Modell für 35-mm-Lüfter
The model supports 3x 3510 (35x35mm) fans for cooling the motor drivers (less noisy than 4010 fans) and 1x 4010 (40x40mm) fan for cooling the CB1/CM4 module, as in the original design. Using slightly smaller fans (3510) allows us to…
