12 modeli
Hello i used 2 magnets and printed the 15mm pin and the wheel At the 15mm pin, glued on a 10x10x5mm magnet. And the other magnet is round 8x3mm, to go on the hole in the extruder. Printed this in PLA with green to yellow color change…
A Stand for the Audient EVO 8 affectionately titled "the cradle", which holds the unit at a pleasing 45 degree angle
“The Cradle” I was sick and tired of my Audient Evo 4 shuffling around my desk… As someone who only has this interface for an overkill XLR mic utilized at my remote job, I haven't cared enough about aesthetics, until now. Given that the…
13,1cm wide, 19,8cm long. Tilted 45 degrees If you would like to support me - you can buy me a coffee :) Also if you liked the model - share photo of your print <3 Check out my other models HERE Any feedback will be highly appreciated!…
Same electrics needed as the Original Model. Hardware changed: Needed Screws: 2× M1.6 6mm screw instead of the 10mm For Lid and Bearing guide 6× M3 8mm countersunk screws For attaching the Motorhousing to the body 4× M3 10-12mm…
A pool has an outlet and an inlet. This part is for the inlet to redirect the water in a 45degree angle. To the bottom or to the center. The adapter has a diameter of around ~47mm. 2mm thread distance and a single starting thread. Source…
A Stand for the Audient EVO 8 affectionately titled "the cradle", which holds the unit at a pleasing 45 degree angle
i just wanted something functional and mnimalist that would work w/ a few different things i was working on, and it did. i printed in petg and flexed a little to make it work, i dont think it would work in pla or pc Category: DIY
A 45 degree canted mount (right side) for use in conjunction with and optic or something Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: Yes Resolution: .2 Infill: 20 Filament: random pla black Category: 3D…
