Liczymy pasujące modele…
Print where the EGO logo is upside down so that supports are not needed. The long flat narrow curved edge will be touching the build plat. Infil percentage can be very low. I used 20%. I have mostly 2.5 ah batteries but this will hold my…
Jednoduchý nástěnný držák na beterie DEWALT 18/56V XR. Prosté jednoduché výstižné Simple wall mount for DEWALT batteries 18/56V XR. Easy, simple, fast
Update 09/05/2019: Did a redesign of this, and did a test this afternoon. Deleted the old STL file. For additional strength, I printed this rotated 59.5 degrees, so that the face down on the bed was flat (see picture). EGO 2823802000 Lawn…
Unsatisfied with the limitations and individual costs of Proslat mounting hooks, I reverse-engineered the EGO battery to create a secure, seamless holder designed specifically for Proslat walls. Two variants are provided: Single-body…
Case for laptop motherboard(ASUS N56VB). Add led strip with diffuser and wifi controller. You'll need to fine-tune it with a file a little. You can add polycarbonate as case cover
Since I mow on a bit of a rough terrain, I guess this clip was lost at some point and I needed a replacement. This seems to exist as a replacement part from Husqvarna and it's cheap, but at the time when I needed it it wasn't in stock…
Frame for Blue Bird Servo BMS-A56V or with the equal size Melt the nut with a soldering iron in to the frame Bottom closed, no adhesive on the servo
Ego 56V AH1530 bumper head, this is NOT the entire bump head, only the part that spins on the bearing and contacts the ground. Update (1/31/2023): Found that the small plastic shaft was weak, so added a 3mm diameter screw and nut to…
This is a simple slide-in device that will allow you to charge your phone, tablet, laptop, etc from a 56v EGO battery. PD 30W and QC 18W are supported via USB-A and USB-C connectors. A volt meter is also included. Hardware needed: 6x M3x8…
This model is designed as a mount for this Ego 56v battery adapter, to allow for mounting on the steer tube of a Bullitt cargo bike. https://makerworld.com/en/models/665368-ego-power-battery-adapter?from=search#profileId-592828
This model is designed as a mount for this Ego 56v battery adapter, to allow for mounting on the steer tube of a Bullitt cargo bike. https://makerworld.com/en/models/665368-ego-power-battery-adapter?from=search#profileId-592828
The Ego CS1800 56V chainsaw suffers from a poor tension mechanism. This simple adapter, along with a 5mm screw (20mm length), 5mm washer and 5mm hex nut, is a “drop in place” fix. The only modification to the cover is to drill a hole for…
Compatible with Echo 56v series batteries Print upright with the triangle points up. No supports, but brim is recommended 4-5 walls requires 3x countersunk screws M4 or similar
Friend of mine was having difficulty printing case for Starlink power supply. I did not like printing with 10mm of supports, so I cut the feet off so they could be printed separately. One version using M3 nuts in the feet one version with…
I created a holder for 2 56V WORX batteries that are used for my WORX lawnmower. Printed with PETG. Created in FreeCAD Hardware: 2 M5 x 25 screws 2 Fender washers Depending on your wall you may need wall anchors
I have an Echo 56V cordless electric string trimmer. Cordless electric means there is a battery charger to take up space. The charger has keyholes for wall mounting, but I don't like having to use a tape measure every time I change my…
