Liczymy pasujące modele…
I wish Hasselblad made a better viewfinder mask for shooting with 907x CFV II 50C digital back on old analog body so I made mine. There are several similar models available here and there, but these are complete set of all crop formats…
Improved filametrix cutter.
A small easy to print comb that holds the PTFE tubes at the correct height to prevent the tubes applying pressure to the gates. Printed mine in PLA and it works fine, recommend ABS if its within a warm area.
Shortened the top to allow the extruder door to open properly. You will need to adjust the cut position to match the divot in the arm since it is shorter. This is a remix from the original arm. credit @sorted - (Filametrix "don't get…
This is a small slightly oversized case that mounts on the bottom of the 2020 profile of the Sturdybunny / ERCF v2 below the filament blocks at the back. Features Accurate USB-C & Power Pass through holes. Left and Right passthroughs at…
Orbiter2.0 SB model adapted for ERCF toolhead sensor, entry sensor & cutter There are only toolhead sensor version and toolhead&entry sensors version, of which the dual sensor version is 1mm higher and refers to the double step design of…
Support Arm Endcap With MMB V2.0 For ERCFV2's mod ERCT Buffer Support MMB V1 & V2
300mm remix with reinforced 2020 rail mounts. Edit 2025-02-03: -added step file for 2020 mounts -added 2020 mount models in 3mf with 0.5 and 1mm larger tolerances for the 2020 extrusion by request. (Untested) -added 2020 mount tolerance…
Voron ERCFV2 top mount Enhanced version Does not affect the sealing
SImple framing guide for Hasselblad 500CM cameras with a CFV50c digital back, without the appropriate focus screen.
This is a longer rear mount for the BTT MMB for the ERCFv2 it is about 20mm longer so that you can still mount it when using longer gate blocks with pre-gate sensors like these . I exported the mount in question from Fusion (which I am…
Supports A0090 as shown in the picture. The A0090 with silver shell does not need to be modified, just use mg90s
Because the line I made is too short, it cannot fit into the original box. So, I made some cuts on the box and added a screw tightening device. I will need a heat-melting nut and a 3*40 screw for this.
Cut off a bit, and it can fit a 24mm high motor.
ERCFv2 Mount for Voron 2.4 DOOMCUBE printers. This mount should also work with standard V2.4 printers. This is installed along the Z extrusions on one side, and mounts 2x 2020 extrusions which mount to the feet of the ERCF. Printed with…
This mod is currently in beta testing and is still undergoing refinement. Use it at your own discretion. I take no responsibility for any damage caused to your unit during installation or operation.
not much more to say, I made them taller because I used to have the spool feeds coming from the front under it and I made the mounting screws a little easier to get to
I accidentally ended up printing a newer X Carriage that replaced the HS inserts with screwholes. While I managed to get two nuts into the holes and managed to insert the left screw I failed misserably inserting the right one. Ther was…
es una estatua de dragon con las alas abiertas
When I replaced my ERCF v3 MMU with the BoxTurtle, I realised the BoxTurtle was missing an encoder, which gives excellent clog detection and enables me to intervene and save a print when I get a toolhead clog. Without the encoder the…
