14 modeli
Join the discord community: https://discord.com/invite/prjUvjmGpZ Join forum: https://discourse.source-robotics.com CM6 uses 6 gimbal BLDC motors paired with small gear ratio gearboxes ( from 5:1 to 9:1), by doing that it is passively…
I needed to rework and mount as much of my networking gear as i could which necessitated removing the modem's stand and constructing a wall mounted solution. The most important goal for me was to make the simplest print i could while not…
I recreated some classic (JDM-)wheels. They're approximately 1:3 scale and have an diameter of around 13.5cm and a width of around 9cm. They're not a perfect copy as I drew them just after some pictures from the internet. Print them as…
Stand for ROG Ally/X that fits the UGREEN CM639 hub
Miele Cm6350 Gear Driver Miele Cm6350 Gear Switch Should be compatible with Melitta 6556235 / Delonghi The gears was broken cause O-ring are old, each 2 years must be replace to avoid to break this parts. You can use Melitta 200930 kit to…
Use this to attach to a wall or to generic DIN rail mounts (available on Amzon, eBay, AliExpress etc) Has access hole for DIN rail clip release. Integral spacers keep upright when DIN rail mounted and spaced away from the wall when wall…
Under desk mount for UGREEN CM662 KVM and remote. Each model has two holes for 4mm screw. Prints with no supports.
My old modem died on me and I was in a pinch and picked up a Netgear CM600 at one of the bix box stores. Well the darn thing does not have a way to wall mount it. Due to space constraints, it had to go on the wall. After utilizing DDG…
Store your CM600 Tools in this nice little Box
Made smol holder for my UGREEN CM630 4K USB capture card. Adhesive mounted. You have a choice of 2 options: V1 - less material but small adhesion area. V2 - needs more material but have larger adhesion area plus 3mm mounting holes if you…
A underdesk Mount for the Ugreen CM639 USB-C Dock. One side has a coutout for the Ethernet port, exept for that both sides are identical. I included the step files if you need to make modifications.
Wanted to keep the plate scratchfree for longer so I designed this nice cover plate for it. It alignes using the 2 center holes and is held in place by 6 round 2mm thick and 6mm in diameter magnets. I glued the magnets in with a small…
how to print 3 models provided. The screw gaps have been calculated to match HSW's lattice. • vertical: device inserted from the top (recommended for a vertical wall mount) • horizontal: device inserted from a side • both/universal: holes…
I have a FYSETC Voron 0.2 R1 Pro kit with the Catalyst 2.0 Motherboard and the fan setup for cooling the processor did not work for me. This clips onto the existing heatsink and uses M2x10 self tapping screws with washers to mount a 4010…
