Liczymy pasujące modele…
I wanted to use a magnetic mount for my cr18p, but none that I found matched what I wanted so I made a set. My targets: use 10mm magnets (round or square). They can be up to 2.35mm thick. do not raise the body minimal supports required…
I printed @James Spadaro's trailer for an SCX24 but ended up buying a Hobbyplus CR18P as a tow rig. So I had to design my own tow hitch for it. I'm using some E6000 to keep it firmly on the CR18P, but you could also put a hole through the…
Chassis kit to fix the shortcomings of the long flat skid on the FX118. This has a 10-degree skid and shortened the frame's bottom rail (battery relocated to slider). I ended up with an ESC above the transmission and the rx on the slider…
the 25 tooth servo arm for 6x6 file I printed one out of PlA and so far it is holding up. I expext it to break soon so I printed a polycarbonat one as a replacement. just as side note I had a hard time geting the polycarbonat (PC) to…
This mod allows to move the servo responsible for shifting gears from the side plate to the gearbox housing. This, in turn, allows the ESC to be moved further forward, thus shifting the weight to the front. Designed to accommodate both…
Printed in PETG, but it'll accept PLA as well. 0.12 layer heigth, 25% infill. Add pause at layer 50 in your slicer to insert the magnets. It'll accept anything from 8x3mm to 12x5mm magnets. I have used M2x12mm screws.
this is a roof skid for a hobby plus cr18p evo pro
Printed in PETG, but it'll accept PLA as well. 0.12 layer heigth, 25% infill. Add pause at layer 50 in your slicer to insert the magnets. It'll accept anything from 8x3mm to 12x5mm magnets. I have used M2x12mm screws.
the 25 tooth servo arm for 6x6 file I printed one out of PlA and so far it is holding up. I expext it to break soon so I printed a polycarbonat one as a replacement. just as side note I had a hard time geting the polycarbonat (PC) to…
