Liczymy pasujące modele…
The wall lamp was inspired by generative design. The original generative design computation has been simplified and reinforced in the VR environment and optimized for 3D printing (no support necessary). The cable of the lamp has been…
No supports needed, no brim, 15 % infill.
This is a remake from the linked Mitsubishi Remote wall holder. The original fit OK, but not quite in my case. I remade the whole model to fit a bit better and slimmed the hook a bit. There are two versions, one with screw holes and one…
Cover that fits the JQ-D022BT module and can be screwed onto a surface or case. The module itself is glued to the cover but holes could be drilled so it can be screwed instead. Can be used with this XH-M567 amplifier box . Model in…
Dummy D02 Schmelzsicherung 50A
* Perpendicular to the Pegboard for easy access and reduced space usage * Clamp Bracket design to prevent it from falling * Strengthened Load-bearing capacity Please glue the parts. *"kitbox holder.3mf" is the holder for the toolbox*…
Ventline replacement fan model BVD0217-00. Printed with ABS and used to replace my RV's fan.
This is a make for the popular IKEA ivar cupboard floor protection. There seems to either be a shortage of those or they are going out of production, I could not find them on the Ikea website any more. So I made my own. I added a screw…
Wall mount for drill or impact with a few slots for spare bits. Can be printed at almost any resolution without significant loss to functionality.
The Xiaomi Mijia Night Light has an adhesive tape base to enable it to be stuck onto various surfaces. My round base allows it to just be placed on a table instead. Print instructions Print in White PLA.
Print this vase in vase mode white 0.2mm layer height on 0.4mm nozzle.
The Wurkkos HD02 is one of my favorite lights of 2025 but one thing that I miss is the ability to twist the wings to illuminate away from a magnetic surface. With this clip the lamp can be magnetically attached overhead so that the…
Its a nice lamp but the button it very easy to press when it is in the trouser pocket. Printed with 0.2 PETG on Mks3+. Also works with PLA. It is designed to be tight enough to stick. Depending on print Settings, maybe you have to adjust…
This is a simple little stand for holding the infinitely useful RavPower WD02 travel router. It's a great little portable router but it's designed like a bar of soap and there are ports on both of the flat ends, which means if you use the…
This is an upgraded base for the Xiaomi Mijia Night Light 2 that replaces the original magnetic cover and offers a much larger adhesive footprint for reliable mounting on textured or uneven surfaces. Now available in three variants so you…
No supports needed, the loop part should be printed with a brim To assemble the loop remove the sacrifical bridges from the magnet head with a knife, insert the loop in the magnet head and secure with the clip.
I made this button cover to prevent accidentally turning on the flashlight in a pocket or bag. Also works great as a red light diffuser and filter at night to preserve night vision. Printed in red TPU95A with 0.8mm nozzle on an Ultimaker 3.
A2I20D020GNR1 3D model can be used in cad software
You need four 4×2 magnets . If you want to mount the vacuum, you first have to remove the magnetically attached air‑intake grill . After that, you can install the adapter. It already holds quite well even without the magnets.
Print in PETG. uxcell silicone foam seal strip 1.5mm (Amazon) if water resistance is desired
Ventline replacement fan model BVD0217-00. Printed with ABS and used to replace my RV's fan.
