Liczymy pasujące modele…
A fairly exact replica of the stock large hood vent. Replaces Yamaha P/N: 8J9-77134-00-00 Since this is the hot air exit of the fan shroud, I'd suggest printing with PETG or better materials. Supports will be needed. Please share any…
A replacement hood vent for the Yamaha Enticer 340. Supports are necessary for the overhangs of the tabs.
Replacement vent for the Yamaha Enticer 250 snowmobile hood vent. will need some supports. Mine was printed in PETG. You will need 2 small machine screws or bolts with nuts to install
The narrow rectangular hood vent behind the windshield for a Yamaha Enticer 340 (ET340). Replacement for Yamaha P/N: 8J4-77109-00-00 Print Settings Rafts: No Supports: No Resolution: 200 Infill: 20 Filament: PolyMaker PLA Category:…
The two halves clamshell over an aftermarket LED headlight. It can then be mounted to the stock location using the original hardware. Printed with supports in PLA. Might recommend PETG for durability. The design utilizes M3 and M5…
The round windsheild defrost hood vent for a Yamha Enticer 340 (ET340). Replacement for Yamaha P/N: 8J9-77133-00-00 Print Settings Rafts: No Supports: No Resolution: 200 Infill: 20 Filament: PolyMaker PLA Category: Automotive
A printable float bowl gasket for the Yamaha Enticer snowmobiles with a rectangular float bowl. I used Ninjatek Ninjaflex TPU (85A) I then covered the gasket with parchment paper and uses a clothes iron to smooth the top surface, This may…
Printed with supports in PLA. Might recommend PETG for durability. The design utilizes M3 heat-set threaded inserts. https://www.mcmaster.com/94180A333/ The M5 threads are printed. They may need to be cleaned up with a tap. It also used…
Modelled off the dimensions of the original choke handle. I lost the roll pin for mine, (which would have worked fine), but I found that a 6/32 machine screw fits perfectly as well.
