Liczymy pasujące modele…
Fuel cap designed for the 2009 Kawasaki KLX 450R . This model was created from scratch and is meant to be printed in hydrocarbon-resistant materials . PLA is not recommended , as it may degrade in contact with gasoline. I used nylon…
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions. I have created a smaller version to fit the right-front corner…
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions. I have created a smaller version to fit the right-front corner…
About We do an annual trip that includes some road riding and occasional after dark shenanigans. This year we are all riding small bikes. My KLX125 didnt have a headlight, so I made the necessary parts to fit one. This will work with…
This cover is designed to shield the Dyno Jet Power Commander FC from water/mud despite being water proof, when mounted on the frame rail as pictured. The window should be printed in flex. Much easier to remove than the side plastic.…
The prior owner did a terrible job with the airbox mod. I ride off road and wanted more protection from water and dirt ingress. I'm adding Frogzskin hydrophobic mesh to the airbox opening. If you can get the wires out of the way there's a…
The original rubber spacer underneath the FTZ7S starter battery in a 2022 Kawasaki KLX-300 dual-sport motorcycle is slightly too thick to fit an aftermarket battery with model/size code YTZ7S (see photos). The original battery is about…
About Needed some lighting for a KLX125 aka DRZ125 which does not have a lighting coil. Considered winding the coil, but really only needed it for a weekend, and a dewalt 20v battery seemed like a common suggestion. I used a cheap adapter…
Print instructions material: PET-G is strong enough, ABS would be better, NYLON is the best infill: 100% for PET-G suports: yes layer: max 0.2 mm Print all parts in horizontally, all layers must be in 90° to the longitudinal axis to avoid…
About We do an annual trip that includes some road riding and occasional after dark shenanigans. This year we are all riding small bikes. My KLX125 didnt have a headlight, so I made the necessary parts to fit one. This will work with…
About Needed some lighting for a KLX125 aka DRZ125 which does not have a lighting coil. Considered winding the coil, but really only needed it for a weekend, and a dewalt 20v battery seemed like a common suggestion. I used a cheap adapter…
Print instructions material: PET-G is strong enough, ABS would be better, NYLON is the best infill: 100% for PET-G suports: yes layer: max 0.2 mm Print all parts in horizontally, all layers must be in 90° to the longitudinal axis to avoid…
