Liczymy pasujące modele…
This mount fits the Maddalena MVM water meter, which is commonly installed in Belgium (Watergroep). The mount holds a proximity sensor with a diameter of 18mm, such as a LJ18A3-8Z/BX. I used this sensor as a pulse counter to get water…
A simple holder to fix an LJ18A3 inductive pulse counter with 18mm diameter to my Elster water meter. Couldn't find the exact type of the water meter, but it has two small (slightly less than 3mm) holes in the outer rim. You need a…
Slight re-mix of lukeskymuh 18mm Inductive Sensor Support. To save material; rounded off the section where the sensor mounts and thinned down the plate where is is held by the part cooling fan screws to 3mm. If I remember correctly it's…
Use-case Plenty of models around, but none that quite worked for me. It's difficult to get the positioning of the sensor just right so I made this model where you can change height and position exactly the way you want. With the arm you…
If my model was usefull for you I would appreciate that you smash the like button and post your make, that would really help.
This is a rear-mounted inductive sensor mount for the Anet A8 Hemera mount. It screws into the holes at the bottom of the x carriage assembly.
Mount for inductive ABL Mega Zero V2.0 Setup Hardware Big thanks to this guy for solving my issues. For Mega Zero V2 you will need to use a 1K resistor between BLUE and BLACK wire to make it work. and a 6.8K for the V1 or other printers…
I wanted a better mount for my LJ18A3-8-Z/AX inductive bed sensor, so I made one which mounts directly to the fan of my Hemera extruder. The bed probe offset ended up being x: -22, y: -40.
