Liczymy pasujące modele…
Small cases for Luckfox Pico Pro/Max (RV1106) and Pico Plus/Mini (RV1103) You can add a piece of clear filament in the hole near the usb-c port to guide the indicator light through (for Pro/Plus/Max). There is also a version without the…
Case and wall mount for the LuckFox PicoKVM. Has cut outs for all ports and buttons. Uses 2.5mm screws for lid (Tight). Depending on the screws you are using to mount the box, you may need to use/print washers.
Heres a case I designed for my Luckfox Pico Plus. Clips together and has a little push button for the Boot button. Pretty simple case but should do the job. Category: Electronics
just added a little wingaling to the side so it would bolt into a rack
This is my attempt at a very small case for the Femtofox Meshtastic node. More information on the Femtofox can be found here: https://github.com/femtofox/femtofox Some notes: Additional Components: N Female to IPX/UFL RG178 Cable - 10 cm…
I designed a frame for the Luckfox 7" HD touchscreen that mounts to the printer frame. The display is mounted on a carrier and can be folded towards the housing as well as completely removed if required. The design is intended for the…
I was looking for a case that was inspired by hak5 sharkjack and could not find anything. After no responses from hak5 after a few attempts to request official permission, I figured I would post this here, though if they ask I will remove…
Case for Luckfox Lyra, with a recess for a 2.1 power connector + hole for a USB cable.
This is an enclosure for the SC3336 camera ( https://s.click.aliexpress.com/e/_c42L6Q2P or on amazon https://amzn.to/4ngrpwI ) that is used with the luckfox pico mini board (https://s.click.aliexpress.com/e/_c33LMcDd or on amazon…
Luckfox Nova case. I printed it with PETG with a layer height of 0.3mm and a nozzle of 0.6mm diameter at pretty high speed; thus the look. As for the screws, I used 2x8mm self tapping screws.
This is mod to allow pico kvm to be placed in a case with 3.5 bay. The size of my 3.5 bay is a bit different 103mm.
A case for a Luckfox PicoKVM Ext Expansion Board including a dummy board and a lid. 4x M2x20 screws and nuts needed.
just added a little wingaling to the side so it would bolt into a rack
Case for Luckfox Lyra, with a recess for a 2.1 power connector + hole for a USB cable.
10 Inch rack for Luckfox Nova/Pico and Raspberry PI 3B 1U height Print Settings: Infill: 15% Gyroid Top: 5, Bottom 4 Perimeters: 3 0.2mm Structural
