Liczymy pasujące modele…
I created this small holder/mount for the Radiomaster RP4TD receiver. It just slides in and stays via friction. If loose just add a dab of hot glue or similar to the edge of the receiver. I print in ASA .4mm nozzle and .2mm layer height.…
You need to glue the top and bottom parts. And allow enough time for it to dry, as the design has very little tolerance. You might need support like the one shown in the photo. v1 Add a version that can be printed in portrait mode. v2 Add…
This remix is to fit this Ice tower cooler from 52pi. https://amzn.asia/d/1SEVfMC I adjusted the top part of the modular case for a specific cooler for the raspberry pi 4. This removes the the ribbon cable holes and makes the fan hole…
This is a cap for the Ryobi RP4400 Flashlight. My Father lost his cap for this flashlight and we didn't feel like spending 10 dollars buying a used cap online, So I 3D designed this one, its a very basic design, allowing it to be quickly…
If you hear Beethoven, he can watch his disk turning. The bust neeeds no support, the statue needs support.
So funny enough my dad somehow also misplaced the drip/grease tray for their Foreman Grill. Rendering the grill unusable since without the tray grease drips onto the counter. Needed my tray to be 12 ¼'' long and could just barely make…
Based on the original design by gleavek. Pretty much exactly the same as the original, but just made the housing 2mm wider inside and outside to fit Radiomaster RP4TD receiver.
Cutout some of the case opening for the SD card access to make it easier to get to for the VESA75 mount. Sneaks orginal work is one of the best things I've printed, it goes together as it should, even when the bottom or top has adhesion…
Printed with 4 walls, 5% adaptive infill. This file is the modivied printer base only. All other parts found here: https://www.printables.com/model/729474-jiose-label-printer-holder-for-skadis-board-with-l Requires 2x 608 bearings as…
pla works fine infill : 20% fill pattern : concentric wall thickness : 3
Paramètre d'impression: 50% en gyroide TPU 95A sainsmart/DFR pour moi le meilleur tpu
I needed a new battery door for my Sanyo RP40 pocket radio, so I designed one in OpenSCAD. Print oriented as-is, with supports. If the layer lines are perpendicular to the battery cover tabs, it'll render them brittle and liable to snap.…
pla works fine infill : 20% fill pattern : concentric wall thickness : 3
If you hear Grieg, he can watch his disk turning. No supports needed.
Delta RP4993 seat (gasket). Print in TPU. Print Settings Printer Brand: Sovol 3D Printer: Sovol SV01 Rafts: No Supports: No Resolution: 0.2 mm Infill: 15% Filament: Giantarm TPU Clear Category: Bathroom
A straightforward print, I successfully used a Creality 3 on default settings. The “filler” piece design file is in the format for that printer. If there's any interest I can include the details of the exact components I utilized. But if…
