Liczymy pasujące modele…
This featherboard works for the Skilsaw Jobsite tablesaw. It uses a 5/16 2" bolt and a nut. The original version did not push far enough toward the blade to give a thin cut, so I had to extend the board a couple inches. I also adjusted…
Watch this video for full install and details: https://youtu.be/ymzXKkLXK9s This great circular saw has only one weakness: no dust collection port. Today we fix that. Prints with no supports needed. If you print with 0.3 layer height and…
This zero-clearance insert fits the Skilsaw 3315 compound miter saw with 10 inch blade. It supports your work right up to the saw kerf for less tearout on the underside. The sacrificial section in the center of the insert is 2mm thick. I…
I printed without support in PLA. The 3rd image shows the dust port that this adapts onto. I used silly putty to extract this profile to 3D model it. You can find and modify it in OnShape here
On the job site I don't have a ducting system and needed to redirect sawdust down into some sort of container or trashbag. This quick little ring and redirection pipe fits snugly into the exhaust port of a Skillsaw Jobsite saw (if you use…
This is designed for a Skilsaw 3317 miter saw. I believe the bolt used is a M14-1.5x60 Printed with a brim. No supports. 100% infill
This is a dado insert for the 8" ¼ SkilSaw portable table saw. The model only needs support on the tabs at the end and hex connectors. There are two versions , full printed on the XL or cut in half for the mk4 or other. PETG, ASA or HTPLA…
I liked the original but I had a couple changes I needed to make. Size was not what I needed. Not the big issue I had, an issue with the rotating hold back part. Since it was just screwed into (threads were very good) the plastic- not…
A very minor change as it was mentioned not everyone wants to wait to drop the lock-nut in and continue printing. I made allowance so the lock-nut can be dropped in after printing. Though you may have to pull the lock-nut all the way in…
SketchUp model and STL of a Skilsaw table saw zero clearance insert for more accurate cutting and dust collection
Removed and 3D modeled from my broken Skilsaw Mitersaw 71/4 blade. #61 on drawing. 8 1/16 long 2 3/16 wide
I made this in two parts for clue after. Printed in PLA, upside down without a top, with 30% grade infil. In red for(to) match the brand.
Printed in TPU. Grooved to latch on to Miter Saw and threaded to insert 39mm spiral vacuum hose. Share your Make:)
