Liczymy pasujące modele…
So basically I really like these headphones, and my only real gripe with them is the long cable which is nice at the desk, but annoying to use with a phone in the pocket. Many headphones solve this by having a plug instead, and supplying…
So today a part which holds the tensioning thing on my Samson SR850s has decided to snap. After 5 years it's understandable I guess. Print instructions: Low layer height, like 0.2 or 0.1 mm (because of in-design supports) 0.4 nozzle…
My cable broke so I 3D modelled and printed a removable cable chaise. Note: Mind the bad soldering still getting the hang of it. :p
FrSky SR8+ receiver mounting. for screw or glue mounting for comfortable work, you can take it out and in easily without glu the receiver itself. I tested it on different models and hard situations. Print parameter: PLA/PETG 0.2 layer…
quick and easy ratcheting toothpaste squeezer with release to remove empty tube. no supports
Replacement headband for the Samson SR 850 headphones. The headphones are an OEM version of the Superlux HD 668B, so it might fit that one as well. Printed using flexible PLA filament. The Superlux HD 681 is a similar model, so this…
I have had an issue with the cable of the Samson SR850 headphones. It break in a few months and while soldering it back is not hard, every time I need to strip more cable making the cable shorter. My soldering job isn't perfect but it…
I just recently got into audio equipment, and this is legitimately the first pair of headphones I can wear for hours on end. I left them alone for a day, then I wanted more. I'm not sure if it makes a bit of a difference, but I added a…
This design is intended to provide for improved precision while adjusting the fan and power settings of the Fresh Roast SR800 and SR540. It is a simple press-on replacement for the original knob that is shipped with the roaster. It fits a…
Replacement Batteries are expensive and of low battery quality, so I decided to make my own using off the shelf cheap AA NiMH 1,2V Batteries. They are like the original cells but a bit longer, so I had to redesign the shell. I used the…
A common breaking point of the Samson SR850 headphones is the cable, as the wire will eventually tear itself from the actual headphones thanks to thin cable wires and minimal strain relief. Luckily, the SR850 is also a great pair for…
A 3D model of a Marantz foot for the SR8001, most likely also compatible with the other Marantz equipment. Is missing the alignment pins. My first try at 3D modeling
You can print it in PLA or PETG, mine is PETG. To install the headband, start by removing the clips that go inside the headband's loops. Then heat a loop using your printer's heatbed (or some other method) until it's pliable enough. Then…
This model allows you to add a removable cable to the Samson SR850 headphones in case your cable breaks, or you need a longer/shorter cable. You will also need some wires and a Philmore model 504K or 504KB, or an equivalent panel-mount…
So today a part which holds the tensioning thing on my Samson SR850s has decided to snap. After 5 years it's understandable I guess. Print instructions: Low layer height, like 0.2 or 0.1 mm (because of in-design supports) 0.4 nozzle…
You can print it in PLA or PETG, mine is PETG. To install the headband, start by removing the clips that go inside the headband's loops. Then heat a loop using your printer's heatbed (or some other method) until it's pliable enough. Then…
