Liczymy pasujące modele…
I think these will fit the x20 (non S model) or the new X20 Pro as well. Let me know if they don't. This model prints upside down and does not require any supports, although I did find I got more reliable adhesion when I printed with a…
I modeled a replacement slider for the FrSky X20 and X20S RC transmitter that flips the long part of the slider to point down. This is more comfortable for me to use during flying. Be very careful trying to fit this on after printing. If…
Stick ends for gimbals on the X20 and X20S FrSky transmitters. You might need to adjust Horizontal Expansion to pull in the outside walls a bit for overextrusion on the outer walls. You can also just increase the size by little amounts in…
I like a bigger back momentary SI button on the X20S so I designed this. It replaces the plastic mechanism on the inside and has a screw on button top. For the internal part, Support should only be used on the flat area that is suspended…
I have a Begode EX20S suspension unicycle, and found that I wasn't really able to use the upper stock power pads very well, as the 'gap' between the front and rear pads is quite large so I found I wasn't even moving my leg back far enough…
Spacer to improve the ergonomics of the FrSky X20S transmitter. I found that the position of the radio was uncomfortable and it weas unnecessarily short. This spacer makes the height more similar to my other radios. Printed in ABS on a…
I decided to upgrade the case for my FrSky X20S and ordered one from AliExpress - https://www.aliexpress.com/item/4000677757547.html (size: 330x235x170mm). The original insert fits right in but leaves a 3cm gap on the side so i designed…
I designed these with a spider web motif, and suggest printing in PETG, or you could try TPU if you're comfortable printing with supports in TPU (I haven't figured that out yet so mine were a mess). They're not large, but provide some…
The bottom corners of the aluminum battery cases on the EX20S are relatively exposed, especially on tight trails and on compression of the suspension and/or tire. I designed these corner protectors to protect the cases from scratches and…
Created these protectors as I preferred the separated design compared to other protectors. I also use larger sticks so needed additional space for them to fit. Printed in PLA on an AnkerMake M5 .2mm layer, 2 walls, 15% infill. Print as…
This rear grip fits directly over the sharp metal edge of your EX20S electric unicycle, giving you a more comfortable option to lift or carry the EUC. The centre hole is to allow fitting without interfering with the screw that comes down…
I designed this easy-to-print front fender as a way to increase the waterproofing on my EX20S. The mounting holes line up with those used for the rear fender bracket to the EUC frame, so simply remove the rear fender by removing the two…
