SV08 Honeycomb Wall Storage enclosure with bonus Gridfinity top
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
SV08 enclosure. Includes honeycomb storage for wall, gridfinity for top. Pairs two ambitious storage projects!
- Rating
- 0 / 5
- Likes
- 41
- Downloads
- 162
- Makes
- 0
- Views
- 1,741
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This model requires zero supports. Instead of overlapping sections, each section is connected using existing methods available in the HSW ecosystem - dual and triple fasteners. Simply print 4 sections that make up a wall, attach them together with HSW fasteners, then bolt it to the side of your SV08 using the M3 screw of your choice. It's that easy!
The sides are about 160g per panel, the rear panels are ~85g since there is no storage required back there, at least in my case, and the top panels are 212g each. This is with 3 walls at 0.4mm width, 4 top layers, 3 bottom, and 15% Hilbert Curve infill. YMMV. I have yet to make a door design that I'm happy with.
The top was a challenge to support. I opted for making a cross out of 1x4 boards and drilling through the top. Also duct tape on the top and rear. Files are labelled T for top, B for bottom, L for left, R for right, and separated into quarters.