1 / 2
The Prize Winner - 3D-Printed Dual Joystick Arcade Controller — image 1
1 / 2

The Prize Winner - 3D-Printed Dual Joystick Arcade Controller

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An arcade controller for twin-stick games

Rating
0 / 5
Likes
9
Downloads
26
Makes
0
Views
521
Reviews
0

Updated at source:

Model information

Category
Video Games
License
Creative Commons — Attribution

My personal twin-stick arcade controller, designed to play classic and modern twin-stick shooter games. A large format printer with a build surface of at least 400mm length is required. See this page on my blog for model details: https://theo.minuspoint.com/2024/09/prize-winner.html 

An overhang test print is included with the same 30-degree overhang the main body has. Use this to determine the optimal printing orientation for cooling. On my printer, the Anycubic Kobra Max with a modded printhead with dual fans, I found that orienting the body along the Y axis will allow the fans to cool the part without moving.

Print Settings

  • 0.6mm nozzle recommended
  • 0.2mm layer height (0.3mm/0.4mm layer height for bottom plate)
  • 8% or more infill
  • 2 wall loops
  • 2 top and bottom layers
  • No supports (Vertical hole overhangs may sag at the top, but it will be covered by the button rims
  • Add mouse ears on the corners — OrcaSlicer has this feature built-in
  • If your bed surface is not larger than 400mm in length, you won't be able to print the skirt

Note that there are a few flaws in my photo model. The first few layers of the overhang sag where my test print did not, most likely because I suspended the cooling fan for too many layers. Additionally, I accidentally made one of the countersink screw holes too large, though I have since corrected it in the STL.

To add buttons to the joystick tops, use the Arcade Bat Top with 24mm Swerry Button Thread.

Bill of Materials

These non-affiliate links are provided for convenience.

If you are using audio jack breakout boards, print two 13mm x 13mm x 5mm cubes to use as standoffs. Mount them in a convenient location near the joysticks using double-sided tape or glue.

4-pole audio cables were chosen for this project as the original intent was to design a battop with three buttons so the triggers, shoulder buttons, and stick buttons can all be mounted on the joysticks, but I wasn't able to come up with a satisfactory design with more than one button. In my build, the extra wires are unconnected, but if I or anyone else can design a battop with three buttons, all four lines will be used, and the shoulder and stick buttons on the top half of the panel will act as extra buttons for those inputs. Until then, you can use standard 2-pole male audio cables and breakout boards or female cables. On a TRRS breakout board, the TIP is wired to a button pin and the SLEEVE is wired to ground.

Alternatively, wire terminals, specifically spring-loaded push terminals, can be used to connect the stick button wires. I used audio cables because they are circular and can potentially self-correct, as well as being removable without tools. Spring terminals can also be corrected without tools, and they have the added advantage of allowing the wires to be easily removed from the shaft.

Tags