BXT-MTB-117 / Santa Cruz Hightower clone shock mud guard
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Guard to keep mud off the shock stanchion on a BXT-MTB-117 / Santa Cruz Hightower v2 clone mountain bike frameset.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 38
- Makes
- 0
- Views
- 558
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About
The BXT-MTB-117 frame, which is a clone of the Santa Cruz Hightower, doesn't have threaded inserts to hold a shock mud guard like the original Santa Cruz frame has. Because of this the shock is prone to getting caked with mud and dirt during a ride.
This is a little fender/mud guard that attaches to the seat tube just above the shock tunnel to keep mud/dirt/grime off of the shock.
It's fairly straightforward. I printed it on its side with a single support for the overhang that goes around the seat tube. Then I used a small strip of 3m double sided adhesive to secure the mud guard as far down as it'd go on the seat tube directly over the shock tunnel. Finally, I placed a zip tie around the mud guard to keep it in place should the sticky tape not be enough.
Print Settings
Printed in PETG, on its side, with a single support for the seat tube overhang. No scaling required.
