1 / 3
BXT-MTB-117 / Santa Cruz Hightower clone shock mud guard — zdjęcie 1
1 / 3

BXT-MTB-117 / Santa Cruz Hightower clone shock mud guard

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Guard to keep mud off the shock stanchion on a BXT-MTB-117 / Santa Cruz Hightower v2 clone mountain bike frameset.

Ocena
0 / 5
Polubienia
8
Pobrania
38
Wydruki
0
Wyświetlenia
558
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

About

The BXT-MTB-117 frame, which is a clone of the Santa Cruz Hightower, doesn't have threaded inserts to hold a shock mud guard like the original Santa Cruz frame has. Because of this the shock is prone to getting caked with mud and dirt during a ride.

This is a little fender/mud guard that attaches to the seat tube just above the shock tunnel to keep mud/dirt/grime off of the shock.

It's fairly straightforward. I printed it on its side with a single support for the overhang that goes around the seat tube. Then I used a small strip of 3m double sided adhesive to secure the mud guard as far down as it'd go on the seat tube directly over the shock tunnel. Finally, I placed a zip tie around the mud guard to keep it in place should the sticky tape not be enough.

 

Print Settings

Printed in PETG, on its side, with a single support for the seat tube overhang. No scaling required.

Tagi