Camera Holder Trident - Webcam
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to use my normal webcam as printer camera but on a trident it is tricky where you put it as they are so bulky. I took inspiration from the extrusion mount from orangetruth but added a round pin at the end to ensure I could secure my camera.
I wasn't sure it was going to be a good fit but it came out really well.
I initially printed it with PLA during my test prints and then I printed it with ABS for the final version however for some reason the ball was a bit smaller with ABS so I have created two models. If you have a well tuned printer then use the tight tolerance one. Worst case you have to sand it a bit rather than have it reprint the whole thing.