LoRa Doomsday Messenger body (Remix)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the body piece to move the USB access hole to better align with the USB port on the Feather ESP32-S2.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 15
- Makes
- 0
- Views
- 587
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
UPDATE: Four versions are now included, two that have accommodations for a LoRa antenna, and two “full body” versions without the antenna gap. Also, I've added a modified middle plate without the lanyard attachment (note that this mid-plate does not include cutouts for the Stemma QT connector or the SD card)
LoRa versions:
- lora-body-modified-lower-usb.stl - For use with the “sandwich” LoRa-enabled configuration described in the write-up at https://adafruit-playground.com/u/squid_jpg/pages/keyboard-featherwing-messenger-powered-by-lvgl#building-the-messenger-3185195
- lora-body-standard-headers-usb.stl - for standalone Feather ESP32-S2 with standard height headers
Full-body versions:
- full-body-low-headers.stl - Again, lower USB port for use with the “sandwich” board configuration that allows a Featherwing to be attached to the top of the feather.
- full-body-standard-headers.stl - for Feathers using standard-height headers.
Printed with the open side face-down. Either use paint-on supports to paint only the underside of the case, or use “supports on build plate only” and put support blockers over the screw holes. I used 15% infill for the prints.