LoRa Doomsday Messenger body (Remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the body piece to move the USB access hole to better align with the USB port on the Feather ESP32-S2.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 587
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
UPDATE: Four versions are now included, two that have accommodations for a LoRa antenna, and two “full body” versions without the antenna gap. Also, I've added a modified middle plate without the lanyard attachment (note that this mid-plate does not include cutouts for the Stemma QT connector or the SD card)
LoRa versions:
- lora-body-modified-lower-usb.stl - For use with the “sandwich” LoRa-enabled configuration described in the write-up at https://adafruit-playground.com/u/squid_jpg/pages/keyboard-featherwing-messenger-powered-by-lvgl#building-the-messenger-3185195
- lora-body-standard-headers-usb.stl - for standalone Feather ESP32-S2 with standard height headers
Full-body versions:
- full-body-low-headers.stl - Again, lower USB port for use with the “sandwich” board configuration that allows a Featherwing to be attached to the top of the feather.
- full-body-standard-headers.stl - for Feathers using standard-height headers.
Printed with the open side face-down. Either use paint-on supports to paint only the underside of the case, or use “supports on build plate only” and put support blockers over the screw holes. I used 15% infill for the prints.