5015 Toolhead KLP1 230
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is just a new toolhead cover I designed for use with a 5015 fan for KLP1 230.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 57
- Makes
- 0
- Views
- 374
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
This is just a new toolhead cover I designed for use with a 5015 fan for KLP1 230.
No supports
2 M3 screws
2 heatstake brass inserts
5015 fan
If you are using the THR board you will need to cut and splice the original fan wire to connect to the board, unless you have the right type of JST connector. Im pretty sure they are smaller than the XH.
Print All Parts
Heat stake the two holes on back of cover
Splice or re-pin 5015
Slide the fan shroud into the 5015 fan
The cover has alignment pins for the 5015 and shroud, set fan and shroud on alignment pins as one unit
Take the Fan Tie downs and place over fan/heat stakes
Install two M3 screws
Install toolhead cover