Anycubic Kobra Go Neo Part Cooler Fan Ducts V.1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Anycubic Kobra Go - Printhead / Part-Cooler & Fan-Ducts - Version 1.0 - May fit other Makes / Models - Revision 1
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 55
- Makes
- 0
- Views
- 713
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Anycubic Kobra Go
Printhead / Part-Cooler & Fan-Ducts
May fit other Makes / Models
Revision 1
By: David Orlo
Part Details
- This was one of the first upgrades I designed and finalized for the Printer. Soon after completing this model, I decided to put more time into learning MeshMixer and made some revisions, namely a much more minimalistic, organic, fluid design. This design is still very functional and offers a different fan combination / setup over the later revisions.
- 60mm Center Radial Fan: Heatbreak Cooler
- Dual 4020 Blower Fans: Two Independent Printhead Ducts
Patreon
Want to support my work or get exclusive 3D content? Check out my Patreon!
- Membership & Single Item Shop Available
- Exclusive 3D Models & Design Files
- In-Depth Tutorial Videos covering Autodesk Tinkercad, MeshMixer & Microsoft 3D Builder
- Guides on 3D Printing: Orca Slicer setups, custom printer builds, and more
- Your support helps me expand my projects, and I'll keep sharing new designs and tutorials with the community!
Support me on Patreon
Tips
- The 'PayPal.me' thing has never worked for me, so in place of that, I have uploaded 3D models ranging in value, available for individual purchase on my Patreon Page.
- I appreciate any signs of gratitude, and I thought it would be cooler if you got something too!
Print Recommendations
- Layer Height: .2
- Infill: 90% +
- Material: PETG / ABS / ASA / PLA +
- Supports: Take the time to manually place supports to avoid any supports within the ductwork.
- Brim: Highly recommended
- Expectations: If your support settings are dialed in, it should work fine, but if you're using the stock setup, I suggest printing this twice.
- The second print with the new duct will likely turn out much nicer, which is the whole point anyway, right.
Setup Recommendations
- The 60mm fan should run at 100% anytime voltage is applied to the hot end or anytime the printer is powered on—unless you enjoy clearing jams, of course.
- I recommend keeping the blower fans synchronized and controlling them together.
Radial Fan Important Note
- I've noticed radial fans have a tendency to stall during rapid side to side and sometimes even front to back motion.
- Manufacturer and bearing type can have some effect on this.
Blower Fan Series Wiring Instructions
For a 12V printer, you could wire two 5V fans in series, but some fans may not appreciate the extra voltage at full power. A 24V printer could run two 12V fans in series.
- Series Wiring:
- Connect positive from Fan A to the printer mainboard.
- Connect negative from Fan B to the printer mainboard.
- Connect the remaining Fan A negative and Fan B positive fan wires together.
-
---
---
### Help Support & Keep My Work Free
https://www.youtube.com/@MeshMaster3D
PLEASE SUB - IT MATTERS A LOT
--