Cover vent
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Easy to install vent that creates airflow helping to prevent heat buildup, dampness, mildew, and odors.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 37
- Makes
- 0
- Views
- 265
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
About this model
I needed some ventilation for the tarp/cover of my boat I use for winter storage. The goal was to create something relatively easy to install, without any sowing.
The model pictured in the instructions below is printed with ASA (strong, cheap and weatherproof) using HIPS support, but any material will work.
Any feedback is highly appreciated. Let me know if any modification is needed for your project.
Bill of materials
I get a small portion of sales generated if purchased via the links below.
Required:
- 4x9x1.6 mm rubber washers
- M4 10mm screws with flat heads
- 3mm EPDM rubber foam sealing strip
- Glue for foam strip (e.g. T7000)
- 4mm M4(OD 6mm) threaded inserts
Optional:
Instructions
1. Rubber seal
Insert and glue the rubber sealing:
 |  |
2. Threaded inserts
Insert the threaded inserts:
3. Mark and cut
Mark the cover and create cut, I used an old solder tip to burn the screw holes.
 |  |  |
Optional:
To prevent any small bugs from getting in, you could also mark and cut a piece of mesh. Use the outside of the ring
4. Screw the vent to the cover
Screw the vent loosely to the cover, and tighten when all screws are gripping the threads.
 |  |  |
Make sure its not leaking:
