SV08 dragon style Volcano hotend mount (Haldis Red Lizard K1 & Others)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is my part to adapt a dragon style volcano-length hotend to the SV08's stock extruder.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 42
- Makes
- 0
- Views
- 831
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
I made this mount to adapt a Dragon style hotend to my SV08. I used a CHCB type heater, but a CHC tube style also works.
The Stock hotend uses proprietary parts and in my experience is prone to heat-creep.
This mount has a separate block to tie it into the lower screw location of the toolhead.
It requires a longer PTFE tube below the extruder, and I needed to add shimming magnets to clearance the toolhead cover. I also needed 2 M3 20mm screws and 2 m3 nuts to mount, as well as a 2.5mm x 6mm to mount the support block. I provided holes to screw to the support block sides but have not seen the need to use them.
Printed in Elegoo ASA using Voron print parameters