1 / 6
SV08 dragon style Volcano hotend mount (Haldis Red Lizard K1 & Others) — zdjęcie 1
1 / 6

SV08 dragon style Volcano hotend mount (Haldis Red Lizard K1 & Others)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is my part to adapt a dragon style volcano-length hotend to the SV08's stock extruder.

Ocena
0 / 5
Polubienia
8
Pobrania
42
Wydruki
0
Wyświetlenia
831
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I made this mount to adapt a Dragon style hotend to my SV08. I used a CHCB type heater, but a CHC tube style also works.

 The Stock hotend uses proprietary parts and in my experience is prone to heat-creep. 

This mount has a separate block to tie it into the lower screw location of the toolhead. 

It requires a longer PTFE tube below the extruder, and I needed to add shimming magnets to clearance the toolhead cover.  I also needed 2 M3 20mm screws and 2 m3 nuts to mount, as well as a 2.5mm x 6mm to mount the support block.   I provided holes to screw to the support block sides but have not seen the need to use them. 

Printed in Elegoo ASA using Voron print parameters

Tagi