Creality Space Pi Lid Stop
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Limit the travel for the Space Pi lid so it doesn't obliterate itself
- Rating
- 5 / 5
- Likes
- 49
- Downloads
- 199
- Makes
- 1
- Views
- 2,062
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
If you find the lid opens too wide, don't have enough space to let it swing all the way open or you're worried about the hinge snapping, this model will assuage your concerns.
Functionally this is the same as the original. I wanted something to better match the design of the Space Pi so I made this. This is a slightly more difficult print, so if you want something easy go for the original design. However, the support settings remain the same while printing so I don't think anyone else will have issues with this model.
The outer faces are updated to keep the same angles as the original Space Pi. Behind the hinge area I've simplified the faces to get rid of the stepped look. I was a bit concerned about random dirt/dust/filament/whatever getting trapped in there. I've also angled the access to the rear panel so the recess isn't so deep – the switch and power cable are easier to access.
Print instructions are the same as the original. It should be printed on its side for both strength of the hole and to keep it round. All the hardware information can be found on his page as well. I haven't added the double sided tape yet, as it's not a requirement, but I plan to do it in the future to keep things tidy.
BOM
1x 4x100 steel rod (I opted for the more expensive High Speed Stainless Steel version, but it was still a bit difficult to hammer it through https://www.amazon.com/dp/B0CQTFBMBX/)