1 / 8
Detachable magnetic exhaust duct attachments for K1/K1C — image 1
1 / 8

Detachable magnetic exhaust duct attachments for K1/K1C

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Use these detachable ducts with my magnetic filter holder mod

Rating
4.5 / 5
Likes
63
Downloads
196
Makes
0
Views
1,410
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

These models are meant to be used in conjunction with the magnetic filter holder mod I created here: Creality K1/K1C exhaust charcoal filter holder for magnetic attachments

If you're a K1C owner and wanted to vent your chamber with ducting AND wanted to keep your charcoal filter (or own a K1 and want to add both), use one of these duct options with my filter holder to attach to the back of your printer. If anything, the reduction in noise alone is worth it.

None of these ducts are an easy print, and that's why I made multiple options. The 75mm (3") flange is the easiest, followed by the 75mm (3") to 100mm (4") flange. The elbows are a bit tricky, especially if you print them in ABS or ASA. Print the one you're most comfortable with.

There are 2 ways I can recommend you print the elbows: either on the outlet facing down or on the elbow shaped like a V.

With the outlet placed on the bed, you'll achieve a more pleasing print but at the cost of potential warping at the mating area to the filter holder:

With the elbow placed on the print bed, it won't look as pretty but it should shrink more evenly:

Here are the visual differences of the two printing options (using ASA) :

No rotation is necessary for the straight ducts. You're free to experiment how to achieve the best results, and I invite you to comment how you did it.

The magnet recesses on all of these ducts have a bit of an angle to them so they can print face down. Use a threshold angle of 5 if you want to keep supports out of the magnet recesses. The magnets were supposed to be a press fit, so there's a hole in the back to help you push them back out if you got the polarities wrong. But due to clearances from different magnet manufacturers and printer tolerances I ended up super gluing them in.

I recommend 4 walls for strength and a higher temp filament like ABS or ASA, but I suppose PETG will be fine too.

BOM
  • 1x my filter holder for magnetic attachments (link at the top)
  • 4x 6x2mm magnets
  • 1x super glue (maybe)

Tags