Black Magic Probe v2.3 Case with Light Pipes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the Black Magic Probe v2.3 with embedded light pipes using clear PETG.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 12
- Makes
- 0
- Views
- 145
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This is only a remix of the top part. You can use the original bottom part.
Printed this on a Bambu Lab X1C with eSUN PLA+. Layer height 0.2mm and infill approximately 25% (shouldn't really matter).
Once printed, take clear PETG filament, and cut a few long pieces using a sharp knife (so it does not deform). Then glue these pieces from the inside using super glue. Push them firm against a flat surface, so the light pipes are as flush as possible with the case. Once the glue is dry, use sharp knife to cut the excess filament flush with the case, from the inside.
For glueing, I found it easier to slightly retract the filament, then apply some glue and push it back in. Don't apply too much, otherwise it will spill on the top surface.