Bed Test - Overhang Test - Calibration Cube - Hole Test - Stringing Test - Bridgeing Test

I have desinged a few test models and hears what you need to know about them:

Calibration Cube:

Print Time:            20min

Size:                      15x15x15mm

It tests how acuate the X,Y, and Z belts are. After it prints you need to mesure it.(with something more acuate than a ruler)

Text Test:

Print Time:            40min

Text:                       0.5mm - 1mm - 1.5mm - 2mm (also on the model)

Its not super useful but it tests how low your nozzle is to the buldplate and how deep the text needs to be. (only when its printed on the bottom of the model) 

Stringing Test:

Print Time:             7min

Base of cone:         5mm

A simple fast test to see how well your printer retracts / how stringy your filament is.

Over Hang Test:

Print Time:               40min

Total curve:              80°

Goes up by:              10°

It tests how much of a overhang your printer can print.

Hole test:

Print Time:                15min

Hole size:                   5mm - 4mm - 3mm - 2mm - 1mm - 0.75mm

Print this this to figure out the size of hole your printer can print with out it closeing up into a solid object. 

Bridgeing Test:

Print Time:                 30min

Bridges:                      30mm - 40mm - 50mm - 60mm - 70mm - 80mm

It tests how far your printer can print with out printing on top top of a layer. (as long as it connects to a platform after) 

If you notice anything rong or anything that can be added to the tests please let  me know

                                                    Thanks for downloading :)