Elite Gourmet Dehydrator Print Ring
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Print Ring (85 mm tall) to print directly from the Elite Gourmet EFD319BNG food dehydrator.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 28
- Makes
- 0
- Views
- 243
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print Ring (85 mm tall) to print directly from the Elite Gourmet EFD319BNG food dehydrator. These are 1 piece prints and just fit on my QIDI Plus 4 build plate (NEEDS 296 mm minimum X & Z). STL and STEP files included.
The print ring has a 10.1mm (0.9mm pitch) threaded opening that fits the standard PC4-M10 bowden tube fittings well. I use a Lazy Susan bearing under the spool while using the print ring. UPDATE - Lazy Susan platform files added, however the bearing I purchased is no longer available on Amazon. You'll need to source one that is sized correctly.
I printed in Sunlu ABS with .4 nozzle and .2mm layer height.
I added a 3mm brim to the interior (interior is easier to trim with deburring tool). The short print ring would have probably printed fine without a brim. Use your judgment based on your typical adhesion results.
On my QIDI Plus 4, used generic ABS settings but changed - 55C chamber, 260C nozzle, 100C bed.
Only supports needed are for the PC4-M10 fitting bung.
I printed mine @ 100% expected these to shrink a bit, but they did not by much. My parts are slightly loose on the bottom and more snug than I'd like on the top. If I were to print these again (on my machine) I'd probably scale the X & Y to 99.5%, but if you typically experience Costanza level ABS shrinkage on your rig then 100% (or more) may work better for you.